Enterasys b5 - Set System Name; Set System Location

set system name
Enterasys B5 CLI Reference 3-27
set system name
Usethiscommandtoconfigureanameforthesystem.
Syntax
set system name [string]
Parameters
Defaults
Ifstringisnotspecified,thesystemnamewillbecleared.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthesystemnametoInformationSystems:
B5(su)->set system name “Information Systems”
set system location
Usethiscommandtoidentifythelocationofthesystem.
Syntax
set system location [string]
Parameters
Defaults
Ifstringisnotspecified,thelocationnamewillbecleared.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthesystemlocationstring:
B5(su)->set system location “Bldg N32-04 Closet 9”
string (Optional)Specifiesatextstringthatidentifiesthesystem.
Note: A name string containing a space in the text must be enclosed in quotes as
shown in the example below.
string (Optional)Specifiesatextstringthatindicateswherethesystemis
located.
Note: A location string containing a space in the text must be enclosed in quotes
as shown in the example below.