Enterasys b5

show snmp persistmode
Enterasys B5 CLI Reference 3-39
show snmp persistmode
Usethiscommandtodisplaytheconfigurationpersistencemodesetting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Bydefault,themodeissetto“autosave,”whichautomaticallysavesconfigurationchangesat
specificintervals.Ifthemodeissetto“manual,”configurationcommandsareneverautomatically
saved.Inordertomakeconfigurationchangespersistentwhenthemodeismanual,thesave
configcommandmustbeissuedasdescribed
in“Configuration PersistenceMode”onpage3‐38.
Example
Thisexampleshowshowtodisplaytheconfigurationpersistencemodesetting.Inthiscase,
persistencemodeissetto“manual”,whichmeansconfigurationchangesarenotbeing
automaticallysaved.
B5(su)->show snmp persistmode
persistmode is manual
show config 3-43
configure 3-44
copy 3-44
delete 3-45
show tftp settings 3-45
set tftp timeout 3-46
clear tftp timeout 3-47
set tftp retry 3-47
clear tftp retry 3-48
For information about... Refer to page...