Enterasys b5

ip igmp query-max-response-time
13-14 IGMP Configuration
ip igmp query-max-response-time
UsethiscommandtosetthemaximumresponsetimeintervaladvertisedinIGMPv2queries.The
no form of this command resets the IGMP maximum response time to the default value of 100
(one tenth of a second).
Syntax
ip igmp query-max-response-time time
no ip igmp query-max-response-time
Parameters
Defaults
None.
Mode
Interfaceconfiguration:B5(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheIGMPquerymaximumresponsetimeintervalto200(2tenths
ofasecond)onVLAN1:
B5(su)->router(Config)#interface vlan 1
B5(su)->router(Config-if(Vlan 1))#ip igmp query-max-response-time 200
ip igmp startup-query-interval
UsethiscommandtosettheintervalbetweengeneralIGMPqueriessentonstartup.Thenoform
ofthiscommandresetstheIGMPstartupqueryintervaltothedefaultvalueof31seconds.
Syntax
ip igmp startup-query-interval time
no ip igmp startup-query-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:B5(su)‐>router(Config‐if(Vlan1))#
time SpecifiestheIGMPmaximumresponsetimeint erval.Validvaluesare
from0to255tenthsofasecond.
The default value is 100 (one tenth of a
second).
time SpecifiestheIGMPstartupqueryinterval.Validvaluesarefrom1to300
seconds.Thedefaultvalueis31seconds.