Enterasys b5

show summertime
Enterasys B5 CLI Reference 3-21
show summertime
Usethiscommandtodisplaydaylightsavingstimesettings.
Syntax
show summertime
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaydaylightsavingstimesettings:
B5(su)->show summertime
Summertime is Enabled and set to ''
Start : SUN MAR 14 02:00:00
End : SUN NOV 7 02:00:00
Offset: 60 minutes (1 hours 0 minutes)
Recurring: yes, starting at 2:00 of the second Sunday of March and ending at 2:00
of the first Sunday of November
set summertime
Usethiscommandtoenableordisablethedaylightsavingstimefunction.
Syntax
set summertime {enable | disable} [zone]
Parameters
Defaults
Ifazonenameisnotspecified,nonewillbeapplied.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtoenabledaylightsavingstimefunction:
B5(su)->set summertime enable
enable|disable Enablesordisablesthedaylightsavingstimefunction.
zone (Optional)Appliesanametothedaylightsavingstimesettings.