Enterasys b5

ip rip send version
20-8 IPv4 Routing Protocol Configuration
ip rip send version
UsethiscommandtosettheRIPversionforRIPupdatepacketstransmittedoutaninterface.The
noversionofthiscommandsetstheversionoftheRIPupdatepacketstoRIPv1.
Syntax
ip rip send version {1 | 2 | r1compatible}
no ip rip send version
Parameters
Defaults
None.
Mode
Interfaceconfiguration:B5(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheRIPsendversionto2forpacketstransmittedontheVLAN 1
interface:
B5(su)->router(Config)#interface vlan 1
B5(su)->router(Config-if(Vlan 1))#ip rip send version 2
ip rip receive version
UsethiscommandtosettheRIPversion(s)forRIPupdatepacketsacceptedonaninterface.The
noversionofthiscommandsetstheacceptablereceiveversionoftheRIPupdatepacketstoRIPv1.
Syntax
ip rip receive version {1 | 2 | 1 2 | none}
no ip rip receive version
Parameters
Mode
Interfaceconfiguration:B5(su)‐>router(Config‐if(Vlan1))#
1 SpecifiesRIPversion1.Thisisthedefaultsetting.
2 SpecifiesRIPversion2.
r1compatible Specifies thatpacketsbesentasversion2packets,buttransmitstheseas
broadcastpacketsratherthanmulticastpacketssothatsystemswhichonly
understandRIPversion1canreceivethem.
1 SpecifiesRIPversion1.Thisisthedefaultsetting.
2 SpecifiesRIPversion2.
12 SpecifiesRIPversions1and2.
none SpecifiesthatnoRIProuteswillbeprocessedonthisinterface.