Enterasys b5 User Manual

show ip address
3-10 Basic Configuration
show ip address
UsethiscommandtodisplaythesystemIPaddressandsubnetmask.
Syntax
show ip address
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythesystemIPaddressandsubnetmask:
B5(su)->show ip address
Name Address Mask
---------------- ---------------- ----------------
host 10.42.13.20 255.255.0.0
set ip address
UsethiscommandtosetthesystemIPaddress,subnetmaskanddefaultgateway.
Syntax
set ip address ip-address [mask ip-mask] [gateway ip-gateway]
set system name 3-27
set system location 3-27
set system contact 3-28
set width 3-28
set length 3-29
show logout 3-29
set logout 3-30
show console 3-30
set console baud 3-31
For information about... Refer to page...
Note: The B5 does not support the ability for a user to configure the host's gateway to be a local
routed interface IP. The host's gateway must exist on a different device in the network if one is
configured.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English