Enterasys b5 - Clear Spantree Portpri

clear spantree portpri
Enterasys B5 CLI Reference 9-37
Parameters
Defaults
Ifsidisnotspecified,portprioritywillbesetforSpanningTree0.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthepriorityofge.1.3to240onSID1
B5(su)->set spantree portpri ge.1.3 240 sid 1
clear spantree portpri
UsethiscommandtoresetthebridgepriorityofaSpanningTreeporttoadefaultvalueof128.
Syntax
clear spantree portpri port-string [sid sid]
Parameters
Defaults
Ifsidisnotspecified,portprioritywillbesetforSpanningTree0.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetthepriorityofge.1.3to128onSID1
B5(su)->clear spantree portpri ge.1.3 sid 1
port‐string Specifiestheport(s)forwhichtosetSpanningTreeportpriority.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage 7‐1.
priority SpecifiesanumberthatrepresentsthepriorityofalinkinaSpanningTree
bridge.Valid
valuesarefrom0to240(inincreme nt sof16)with0
indicatinghighpriority.
sidsid (Optional)SetsportpriorityforaspecificSpanningTreeidentifier.Valid
valuesare0‐4094.Ifnotspecified,SID0isassumed.
port‐string Specifiestheport(s)forwhichtosetSpanningTreeportpriority.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage 7‐1.
sidsid (Optional)ResetstheportpriorityforaspecificSpanningTreeidentifier.
Validvaluesare0‐
4094.Ifnotspecified,SID0willbeassumed.