EasyManua.ls Logo

Enterasys b5

Enterasys b5
714 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
set telnet
Enterasys B5 CLI Reference 3-37
Example
ThisexampleshowshowtodisplayTelnetstatus:
B5(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
UsethiscommandtoenableordisableTelnetontheswitch.
Syntax
set telnet {enable | disable} [inbound | outbound | all]
Parameters
Defaults
Ifnotspecified,bothinboundandoutboundTelnetservicewillbeenabled.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisableinboundandoutboundTelnetservices:
B5(su)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
telnet
UsethiscommandtostartaTelnetconnectiontoaremotehost.TheEnterasysB5switchallowsa
totaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Syntax
telnet host [port]
Parameters
Defaults
Ifnotspecified,thedefaultportnumber23willbeused.
enable|disable EnablesordisablesTelnetservices.
inbound|
outbound|all
(Optional)Specifiesinboundservice(theabilitytoTelnettothisswitch),
outboundservice(theabilitytoTelnettootherdevices),orall(both
inboundandoutbound).
host SpecifiesthenameorIPaddressoftheremotehost.
port (Optional)Specifiestheserverportnumber.

Table of Contents