Enterasys b5

To Next Page

To Previous Page

set port duplex

Enterasys B5 CLI Reference 7-13

Example

ThisexampleshowshowtodisplaythedefaultduplexsettingforEthernetport14inslot 3:

B5(su)->show port duplex ge.3.14

default duplex mode is full on port ge.3.14.

set port duplex

Usethiscommandtosetthedefaultduplextypeforoneormoreports.Thiscommandwillonly

takeeffectonportsthathaveauto‐negotiationdisabled.

Syntax

set port duplex port-string {full | half}

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

Thisexampleshowshowtosetge.1.17tofullduplex:

B5(su)->set port duplex ge.1.17 full

port‐string Specifiestheport(s)forwhichduplextypewillbeset.Foradetailed

descriptionofpossibleport‐stringvalues,referto“PortStringSyntax

UsedintheCLI”onpage7‐1.

full|half Setstheport(s)tofull‐duplexorhalf‐duplexoperation.