Enterasys b5 - Set Lldp Port Location-Info

set lldp port location-info
Enterasys B5 CLI Reference 6-27
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablestransmittingLLDP‐MEDtrapsonportsge.1.1throughge.1.6.
B5(rw)->set lldp port med-trap enable ge.1.1-6
set lldp port location-info
UsethiscommandtoconfigureLLDP‐MEDlocationinformationonaportorrangeofports.
Currently,onlyEmergencyCallServices(ECS)EmergencyLocationIdentificationNumber(ELIN)
issupported.
Syntax
set lldp port location-info elin elin-string port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Afteryouconfigurealocationinformationvalue,youmustalsoconfiguretheporttosendthe
LocationInformationTLVwiththesetlldpporttx‐tlvcommand.Thisexampleconfiguresthe
ELINidentifier5551234567onportsge.1.1throughge.1.6andthenconfigurestheportstosend
theLocationInformationTLV.
B5(rw)->set lldp port location-info 5551234567 ge.1.1-6
B5(rw)->set lldp port tx-tlv med-loc ge.1.1-6
enable EnablestransmittingLLDP‐MEDtrapsonthespecifiedports.
disable DisablestransmittingLLDP‐MEDtrapsonthespecifiedports.
port‐string Specifiestheportorrangeofportstobeaffected.
elin SpecifiesthattheECSELINdataformatistobeused.
elin‐string Specifiesthelocationidentifier.Valuecanbe from10to25numerical
characters.
port‐string Specifiestheportorrangeofportstobeaffected.