Enterasys b5

show ssl
Enterasys B5 CLI Reference 3-53
Example
ThisexampleshowshowtodisableWebViewontheswitch:ssl
B5(rw)->set webview disable
show ssl
UsethiscommandtodisplaySSLstatus.
Syntax
show ssl
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySSLstatus:
B5(rw)->show ssl
SSL status: Enabled
set ssl
UsethiscommandtoenableordisabletheuseofWebViewoverSSLport443.Bydefault,SSLis
disabledontheswitch.Thiscommandcanalsobeusedtoreinitializethehostkeythatisusedfor
encryption.
Syntax
set ssl {enabled | disabled | reinitialize | hostkey reinitialize}
Parameters
Defaults
Bydefault,SSLisdisabledontheswitch.
Mode
Switchcommand,read‐write.
enabled|disabled EnablesordisablestheabilitytouseWebViewoverSSL.
reinitialize StopsandthenrestartstheSSLprocess.
hostkeyreinitialize StopsSSL,regeneratesnewkeys,andthenrestartsSSL.