Enterasys b5

Commands
4-2 Configuring System Power and PoE
Commands
show inlinepower
Usethiscommandtodisplaysystempower properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaysystempowerproperties:
B5(su)->show inlinepower
Detection Mode : auto
Unit Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap Mgmt Mode
---- ------ ------- ------------- -------- ------------ ---- ---------
1 auto 375 0.00 0.00 80 enable realtime
Table 4‐2providesanexplanationofthecommandoutput.
4 34 watts (802.3at)
Reserved (802.3af)
12.95 to 25.5 watts (802.3at)
Treat as class 0 (802.3af)
Table 4-1 PoE Powered Device Classes
Class Power Output at Port Power Range Used by Device
For information about... Refer to page...
show inlinepower 4-2
set inlinepower threshold 4-3
set inlinepower trap 4-4
set inlinepower detectionmode 4-4
show port inlinepower 4-5
set port inlinepower 4-6
set inlinepower management 4-7