set policy rule
Enterasys B5 CLI Reference 11-11
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Apolicyclassificationrulehastwomainparts:TrafficDescriptionandActions.TheTraffic
Descriptionidentifiesthetypeoftraffictowhichtherulewillpertain.Actionsspecifywhether
thattrafficwillbeassignedclassofservice,assignedtoaVLAN,orboth.
Table 11‐3providesthesetpolicyruledata
valuesthatcanbeenteredforaparticularparameter,
andthemaskbitsthatcanbeenteredforeachclassifierassociatedwiththatparameter.
maskmask (Optional)Specifiesthenumberofsignificantbitstomatch,dependenton
thedatavalueentered.RefertoTable 11‐3forvalidvaluesforeach
classificationtype
anddatavalue.
vlanvlan SpecifiestheactionoftheruleistoclassifytoaVLANID.
coscos Specifies theactionoftheruleistoclassifytoaClass‐of‐ServiceID.Valid
valuesare0‐4095.Avalueof‐1indicatesthatnoCoSforwarding
behaviormodification
isdesired.(NotsupportedonB3,B5,C3,C5,and
G3.)
drop|forward Specifiesthatpacketswithinthisclassificationwillbedroppedor
forwarded.
Table 11-3 Valid Values for Policy Classification Rules
Classification Rule Parameter data value mask bits
ether Type field in Ethernet II packet:
1536 - 65535 or 0x600 - 0xFFFF
Not applicable.
ipproto Protocol field in IP packet:
0 - 255 or 0 - 0xFF
Not applicable.
Destination or Source IP Address:
ipdestsocket
ipsourcesocket
IP Address in dotted decimal
format: 000.000.000.000 and
(Optional) post-fixed port: 0 -
65535
1 - 48
iptos Type of Service field in IP packet:
0 - 252 or 0 - 0xFC
Not applicable.
Destination or Source MAC:
macdest
macsource
MAC Address: 00-00-00-00-00-
00
1 - 48
Destination or Source TCP port:
tcpdestport
tcpsourceport
TCP Port Number:
0 - 65535 or 0 - 0xFFFF
1 - 16
Destination or Source UDP port:
udpsourceport
udpdestport
UDP Port Number:
0 - 65535 or 0 - 0xFFFF
1 - 16