Enterasys b5

Transmit Queue Monitoring Configuration set txqmonitor
5-2
set txqmonitor
Usethiscommandtoenableordisabletransmitqueuemonitoringontheswitch.Transmitqueue
monitoringisenabledbydefault.
Syntax
set txqmonitor {enable | disable}
Parameters
Defaults
Monitoringisenabledbydefault.
Mode
Switchcommand,read‐write.
Example
Thisexampledisablestransmitqueuemonitoringontheswitch.
B5(su)-> set txqmonitor disable
set txqmonitor downtime
Usethiscommandtoconfigurethetimeinterval,inseconds,thatportsdisabledbythetransmit
queuemonitoringfeatureremaindisabled.
Syntax
set txqmonitor downtime seconds
Parameters
clear txqmonitor 5-4
show txqmonitor 5-5
show txqmonitor flowcontrol 5-6
show txqmonitor port 5-6
For information about... Refer to page...
enable|disable Enablesordisablestransmitqueuemonitoringontheswitch.
Monitoringisenabledbydefault.
seconds Specifiesthedowntimeinseconds.Avalueof0willsetthedowntimeto
forever,meaningthatdisabledportswillremaindisableduntilcleared
manuallyoruntiltheirnextlinkstatetransition.
Thedefaultvalueis0.