Enterasys b5

set port txq
12-8 Port Priority Configuration
ge.1.10 WRR 10 10 15 20 25 20 0 0
set port txq
UsethiscommandtosetQoStransmitqueuearbitrationvaluesforphysicalports.
Syntax
set port txq port-string value0 value1 value2 value3 value4 value5 value6 value7
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Queuescanbesetforstrictpriority(SP)orweightedround‐robin(WRR).IfsetforWRRmode,
weightsmaybeassignedtothosequeueswiththiscommand.Weightsarespecifiedintherangeof
0to100percent.Weightsspecifiedforqueues0through7onanyportmusttotal
100percent.
Examples
Thisexampleshowshowtochangethearbitrationvaluesfortheeighttransmitqueuesbelonging
toge.1.1:
B5(su)->set port txq ge.1.1 10 10 10 10 10 10 10 30
Thisexampleshowshowtochangethealgorithmtostrictpriorityfortheeighttransmitqueues
belongingtoge.1.1:
B5(su)->set port txq ge.1.1 0 0 0 0 0 O O 100
B5(su)->show port txq
ge.1.1
Port Alg Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7
----- --- --- --- --- --- --- --- --- ---
ge.1.1 STR SP SP SP SP SP SP SP SP
clear port txq
Usethiscommandtoclearporttransmitqueuevaluesbacktotheirdefaultvalues.
Syntax
clear port txq port-string
port‐string Specifiesport(s)onwhichtosetqueuearbitrationvalues.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 7‐1.
Onlyphysicalportscanbeconfiguredwiththiscommand.LAGports
cannotbeconfigured.
value0‐value7 Specifiespercentagetoallocate
toaspecifictransmitqueue.Thevalues
musttotal100percent.