Enterasys b5

set snmp persistmode
3-40 Basic Configuration
set snmp persistmode
Usethiscommandtosettheconfigurationpersistencemode,whichdetermineswhetheruser‐
definedconfigurationchangesaresavedautomatically,orrequireissuingthesaveconfig
command.See“ConfigurationPersistenceMode”onpage3‐38formoreinformation.
Syntax
set snmp persistmode {auto | manual}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosettheconfigurationpersistencemodetomanual:
B5(su)->set snmp persistmode manual
save config
Usethiscommandtosavetherunningconfiguration.Ifapplicable,thiscommandwillsavethe
configurationtoallswitchmembersinastack.
Syntax
save config
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosavetherunningconfiguration:
B5(su)->save config
auto Setstheconfigurationpersistencemodetoautomatic.Thisisthedefault
state.
manual Setstheconfigurationpersistencemodetomanual.Inordertomake
configurationchangespersistent,the saveconfigcommandmustbe
issuedasdescribedin“saveconfig”onpage3‐40.Thismodeisusefulfor
revertingback
tooldconfigurations.