Enterasys b5 User Manual

Enterasys B5 CLI Reference 20-1
20
IPv4 Routing Protocol Configuration
ThischapterdescribestheIPv4RoutingProtocolConfigurationsetofcommandsandhowtouse
them.

Configuring RIP
RIP Configuration Task List and Commands
Table 20‐1liststhe tasksandcommandsassociatedwithRIPconfiguration.Commandsare
describedintheassociatedsectionasshown.
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 18-2.
For information about... Refer to page...
Configuring RIP 20-1
Configuring IRDP 20-11
Table 20-1 RIP Configuration Task List and Commands
To do this... Use these commands...
Enable RIP configuration mode. “router rip” on page 20-2
Enable RIP on an interface. “ip rip enable” on page 20-7
Configure an administrative distance. “distance” on page 20-3
Allow reception of a RIP version. “ip rip send version” on page 20-8
Allow transmission of a RIP version. “ip rip receive version” on page 20-8
Configure RIP simple authentication. “ip rip authentication-key” on page 20-9
Configure RIP encrypted authentication. “ip rip message-digest-key” on page 20-9
Disable automatic route summarization
(necessary for enabling CIDR)
“no auto-summary” on page 20-4
Activate split horizon or poison-reverse. “split-horizon poison” on page 20-4
Suppress sending routing updates. “passive-interface” on page 20-5

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English