Enterasys b5

clear spantree legacypathcost
9-32 Spanning Tree Configuration
clear spantree legacypathcost
UsethiscommandtosettheSpanningTreedefaultvalueforlegacypathcostto802.1tvalues.
Syntax
clear spantree legacypathcost
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleclearsthelegacypathcostto802.1tvalues.
B5(rw)->clear spantree legacypathcost
show spantree autoedge
Usethiscommandtodisplaythestatusofautomaticedgeportdetection.
Syntax
show spantree autoedge
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythestatusoftheautomaticedgeportdetectionfunction:
B5(rw)->show spantree autoedge
autoEdge is currently enabled.
set spantree autoedge
Usethiscommandtoenableordisabletheautomaticedgeportdetectionfunction.
Syntax
set spantree autoedge {disable | enable}