Enterasys b5 - Set Lldp Port Network-Policy

set lldp port network-policy
Enterasys B5 CLI Reference 6-29
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleconfiguresthemanagementaddress,MEDcapability,MEDnetworkpolicy,and
MEDlocationidentificationTLVstobesentinLLDPDUsbyport
ge.1.1.
B5(rw)->set lldp port tx-tlv mgmt-addr med-cap med-pol med-loc ge.1.1
set lldp port network-policy
UsethiscommandtoconfigureLLDPnetworkpoliciesforasetofapplicationsonaportorrange
ofports.ThepoliciesconfiguredwiththiscommandaresentinLLDPDUsasLLDP‐MED
NetworkPolicyTLVs.MultipleNetworkPolicyTLVscanbesentinasingleLLDPDU.
Syntax
set lldp port network-policy {all | voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice | video-conferencing | streaming-video |
video-signaling} [state {enable | disable}] [tag {tagged | untagged}]
[vid {vlan-id | dot1p}] [cos cos-value] [dscp dscp-value] port-string
Parameters
med‐cap LLDP‐MEDCapabilitiesTLV. Valuesentindicatesthecapabilities
(whetherthedevicesupportslocationinformation,network policy,
extendedpowerviaMDI)andDeviceType(networkconnectivity
device)ofthesendingdevice.
med‐pol LLDP‐MEDNetworkPolicyTLV.Valuessentincludeapplication
name,VLANtype(taggedoruntagged),VLANID,and
bothLayer2
andLayer3prioritiesassociatedwithapplication,forallapplications
enabledontheport.Seethesetlldpportnetwork‐policycommand
formoreinformation.
med‐loc LLDP‐MEDLocationIdentificationTLV.ValuesentistheECSELIN
valueconfiguredontheport.Seethesetlldpportlocation
‐info
commandformoreinformation.
med‐poe LLDP‐MEDExtendedPowerviaMDITLV.Valuessentincludethe
PowerLimit(totalpowertheportiscapableofsourcingovera
maximumlengthcable)andthepowerpriorityconfiguredonthe
port.OnlyvalidforPoE‐enabledports.
port‐string Specifiestheport
orrangeofportstobeaffected.
all Configuresallapplications.
voice Configuresthevoiceapplication.
voice‐signaling Configuresthevoicesignalingapplication.
Thisapplicationwillnotbeadvertisedifthevoiceapplicationis
configuredwiththesameparameters.