Enterasys b5 User Manual

set port priority-queue
Enterasys B5 CLI Reference 12-5
Defaults
Ifport‐stringisnotspecified,priorityqueueinformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaypriorityqueueinformationforge.1.1.Inthiscase,frameswith
apriorityof0areassociatedwithtransmitqu eue1;frameswith1or2priority,areassociatedwith
transmitqueue0;andsoforth:
B5(su)->show port priority-queue ge.1.1
Port P0 P1 P2 P3 P4 P5 P6 P7
--------- -- -- -- -- -- -- -- --
ge.1.1 1 0 0 2 3 4 5 5
set port priority-queue
Usethiscommandtomap802.1D(802.1p)prioritiestotransmitqueues.
Syntax
set port priority-queue port-string priority queue
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thiscommandenablesyoutochangethetransmitqueue(0to5,with0beingthelowestpriority
queue)foreachportpriorityoftheselectedport.Youcanapplythenewsettingstooneormore
ports.
port‐string Specifiestheport(s)forwhichtosetpriority‐to‐queuemappings.For
a
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage 7‐1.
priority Specifiesavalueof0through7(0isthelowestlevel)thatdetermines
whatpriorityframeswillbetransmittedonthetransmitqueueenteredin
thiscommand.
queue Specifies
avalueof0through5(0isthelowestlevel)thatdeterminesthe
queueonwhichtotransmittheframeswiththeportpriorityenteredin
thiscommand.
Note: Although there are 8 queues, only queues 0 through 5 may be configured.
Queues 6 and 7 are reserved for management traffic.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English