Enterasys b5

Configuring IRDP
Enterasys B5 CLI Reference 20-11
Configuring IRDP
Purpose
ToenableandconfiguretheICMPRouterDiscoveryProtocol(IRDP)onaninterface.Thisprotocol
enablesahosttodeterminetheaddressofarouteritcanuseasadefaultgateway.Itisdisabledby 
default.
Commands
ip irdp enable
UsethiscommandtoenableIRDPonaninterface.ThenoformofthiscommanddisablesIRDPon
aninterface.
Syntax
ip irdp enable
no ip irdp enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:B5(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableIRDPontheVLAN1interface:
B5(su)->router(Config)#interface vlan 1
B5(su)->router(Config-if(Vlan 1))#ip irdp enable
For information about... Refer to page...
ip irdp enable 20-11
ip irdp maxadvertinterval 20-12
ip irdp minadvertinterval 20-12
ip irdp holdtime 20-13
ip irdp preference 20-13
ip irdp broadcast 20-14
show ip irdp 20-14