Enterasys b5 - Clear Macauthentication Reauthperiod

clear macauthentication reauthperiod
22-34 Authentication and Authorization Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ChangingtheReauthPeriodwiththesetmacauthenticationreauthperiodcommanddoesnot
affectcurrentsessions.Newsessionswillusethecorrectperiod.
Example
ThisexampleshowshowtosettheMACreauthenticationperiodto7200seconds(2hours)on
ge.2.1through5:
B5(su)->set macauthentication reauthperiod 7200 ge.2.1-5
clear macauthentication reauthperiod
UsethiscommandtocleartheMACreauthenticationperiodononeormoreports.
Syntax
clear macauthentication reauthperiod [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,thereauthenticationperiodwillbeclearedonallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtogloballycleartheMACreauthenticationperiod:
B5(su)->clear macauthentication reauthperiod
time Specifiesthenumberofsecondsbetweenreauthenticationattempts.Valid
valuesare1‐4294967295.
port‐string Specifiestheport(s)onwhichtosettheMACreauthenticationperiod.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 7‐1.
port‐string (Optional)ClearstheMACreauthenticationperiodonspecificport(s).Fora 
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 7‐1.