To Next Page

To Previous Page

Configuring Classification Rules

11-6 Policy Classification Configuration

Configuring Classification Rules

Purpose

Toreview,create,assign,andunassignclassificationrulestopolicyprofiles.Thismapsuser

profilestoprotocol‐basedframefilteringpolicies.

Commands

show policy rule

Usethiscommandtodisplaypolicyclassificationruleinformation.

Syntax

show policy rule [all | admin-profile | profile-index] [ether |ipproto |

tcpsourceport | udpdestport | udpsourceport] [data] [mask mask] [port-string port-

string] [rule-status {active | not-in-service | not-ready}] [storage-type {non-

volatile | volatile}] | [drop | forward] [dynamic-pid dynamic-pid] [cos cos]

[admin-pid admin-pid] [-verbose] [usage-list] [display-if-used]

Parameters

Note: B3, B5, C3, C5, and G3 devices support profile-based CoS traffic rate limiting only. Policy

rules specifying CoS will only rate limit on D2, C2 and B2 devices, including when C2 and B2

devices are configured on mixed stacks containing B3 and C3 devices.

For information about... Refer to page...

show policy rule 11-6

show policy capability 11-8

set policy rule 11-10

clear policy rule 11-12

clear policy all-rules 11-13

all|admin‐

profile|profile‐

index

Displayspolicyclassificationrulesforallprofiles,theadmin‐profile,orfor

aspecificprofileindexnumber.Validvaluesare1‐1023.

ether DisplaysEthernettypeIIrules.

ipproto DisplaysIPprotocolfieldinIPpacketrules.

ipdestsocket DisplaysIPdestinationaddressrules.

ipsourcesocket DisplaysIPsource

addressrules.

iptos DisplaysTypeofServicerules.

macdest DisplaysMACdestinationaddressrules.

macsource DisplaysMACsourceaddressrules.

tcpdestport DisplaysTCPdestinationportrules.

Enterasys b5 User Manual

Questions and Answers: