Enterasys b5

set logout
3-30 Basic Configuration
Example
ThisexampleshowshowtodisplaytheCLIlogoutsetting:
B5(su)->show logout
Logout currently set to: 10 minutes.
set logout
Usethiscommandtosetthetime(inminutes)anidleconsoleorTelnetCLIsessionwillremain
connectedbeforetimingout.
Syntax
set logout timeout
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthesystemtimeoutto10minutes:
B5(su)->set logout 10
show console
Usethiscommandtodisplayconsolesettings.
Syntax
show console [baud] [bits] [flowcontrol] [parity] [stopbits]
Parameters
Defaults
Ifnoparametersarespecified,allsettingswillbedisplayed.
timeout Setsthenumberofminutesthesystemwillremainidlebeforetimingout.
baud (Optional)Displaystheinput/outputbaudrate.
bits (Optional)Displaysthenumberofbitspercharacter.
flowcontrol (Optional)Displaysthetypeofflowcontrol.
parity (Optional)Displaysthetypeofparity.
stopbits (Optional)Displaysthenumberofstopbits.