Enterasys b5

Enterasys B5 CLI Reference 6-1
6
Discovery Protocol Configuration
Thischapterdescribeshowtoconfigurediscoveryprotocols.Formoreextensiveconfiguration
information,refertothe“ConfiguringNeighborDiscovery”featureguideontheEnterasys
Networkswebsite:https://extranet.enterasys.com/downloads/
Configuring CDP
Purpose
ToreviewandconfiguretheEnterasysCDPdiscoveryprotocol.Thisprotocolisusedtodiscover
networktopology.Whenenabled,thisprotocolallowsEnterasysdevicestosendperiodicPDUs
aboutthemselvestoneighboringdevices.
Commands
ThecommandsusedtoreviewandconfiguretheCDPdiscoveryprotocolarelistedbelow.
For information about... Refer to page...
Configuring CDP 6-1
Configuring Cisco Discovery Protocol 6-7
Configuring Link Layer Discovery Protocol and LLDP-MED 6-13
For information about... Refer to page...
show cdp 6-2
set cdp state 6-3
set cdp auth 6-4
set cdp interval 6-4
set cdp hold-time 6-5
clear cdp 6-5
show neighbors 6-6