Enterasys b5

To Next Page

To Previous Page

set dhcp pool

Enterasys B5 CLI Reference 16-13

set dhcp pool

UsethiscommandtocreateandassignanametoaDHCPserverpoolofaddresses.Upto16

addresspoolsmaybeconfiguredonaEnterasysB5.Notethatenteringthiscommandisnot

requiredtocreateanaddresspoolbeforeconfiguringotheraddresspoolparameters.

Syntax

set dhcp pool poolname

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

Thisexamplecreatesanaddresspoolnamed“auto1.”

B5(rw)->set dhcp pool auto1

set dhcp pool next-server 16-21

clear dhcp pool next-server 16-21

set dhcp pool lease 16-22

clear dhcp pool lease 16-22

set dhcp pool default-router 16-23

clear dhcp pool default-router 16-23

set dhcp pool dns-server 16-24

clear dhcp pool dns-server 16-24

set dhcp pool domain-name 16-25

clear dhcp pool domain-name 16-25

set dhcp pool netbios-name-server 16-26

clear dhcp pool netbios-name-server 16-26

set dhcp pool netbios-node-type 16-27

clear dhcp pool netbios-node-type 16-27

set dhcp pool option 16-28

clear dhcp pool option 16-29

show dhcp pool configuration 16-29

For information about... Refer to page...

poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31

charactersinlength.