To Next Page

To Previous Page

set nodealias

14-40 Logging and Network Management

Defaults

Ifport‐stringisnotspecified,nodealiasconfigurationswillbedisplayedforallports.

Mode

Switchcommand,read‐only.

Example

Thisexampleshowshowtodisplaynodealiasconfigurationsettingsforportsge.2.1through9:

B5(rw)->show nodealias config ge.2.1-9

Port Number Max Entries Used Entries Status

----------- ----------- ------------ ------

ge.2.1 16 0 Enable

ge.2.2 47 0 Enable

ge.2.3 47 2 Enable

ge.2.4 47 0 Enable

ge.2.5 47 0 Enable

ge.2.6 47 2 Enable

ge.2.7 47 0 Enable

ge.2.8 47 0 Enable

ge.2.9 4000 1 Enable

Table 14‐8providesanexplanationofthecommandoutput.

set nodealias

Usethiscommandtoenableordisableanodealiasagentononeormoreports,orsetthe

maximumnumberofaliasentriesstoredperport.

Syntax

set nodealias {enable | disable | maxentries maxentries} port-string

Parameters

Table 14-8 show nodealias config Output Details

Output Field What It Displays...

Port Number Port designation.

Max Entries Maximum number of alias entries configured for this port.

Used Entries Number of alias entries (out of the maximum amount configured) already used by

this port.

Status Whether or not a node alias agent is enabled (default) or disabled on this port.

enable|disable Enables ordisablesanodealiasagent.

maxentriesmaxentries Setthemaximumnumberofaliasentriesstoredperport.Validrange

is0to4096.Thedefaultvalueis32.

port‐string Specifiesthe port(s)onwhichtoenable/disablenodealiasagentorset

amaximumnumberofstoredentries.

Enterasys b5 User Manual

Questions and Answers: