To Next Page

To Previous Page

clear sflow port poller

24-12 sFlow Configuration

clear sflow port poller

Usethiscommandtochangethepollerintervalortoremovepollerinstances.

Syntax

clear sflow port port-string poller [interval]

Parameters

Defaults

Ifintervalisnotspecified,thepollerinstanceiscleared.

Mode

Switchcommand,read‐write.

Example

Thisexampleremovesthepollerinstanceonportge.1.1.

B5(su)->clear sflow port ge.1.1 poller

set sflow port sampler

Usethiscommandtoconfiguresamplerinstancesonports,ordatasources.

Syntax

set sflow port port-string sampler {index | maxheadersize bytes | rate rate}

Parameters

port‐string Specifiestheportorportsonwhichthepollerinstanceisbeingcleared.

interval (Optional)Specifiesthatthepollingintervalshouldbeclearedto0.A

valueof0disablescountersampling.

port‐string Specifiestheportorports(datasources)onwhichthesamplerinstance

isbeingconfigured.

index IndexnumberinthesFlowReceiversTableforthereceiver/Collector

withwhichthesamplerinstanceisassociated.Theindexcanrangefrom

1to8.

maxheadersizebytes Specifiesthemaximumnumberofbytesthatshould

becopiedfromthe

samplerpacket.Thevaluecanrangefrom20to256bytes.Thedefaultis

128bytes.

raterate Specifiesthestatisticalsamplingrateforsamplingfromthisdata

source.Thevalueofratespecifiesthenumberofincomingpacketsfrom

whichonepacketwillbesampled.Forexample,

iftherateis1024,one

packetwillbesampledfromevery1024ingressingpacketsonthisdata

source.

Theratecanrangefrom1024to65 536.Avalueof0disablessampling.

Thedefaultvalueis0.

Enterasys b5 User Manual

Questions and Answers: