Enterasys b5 - Show Arpinspection Ports

show arpinspection ports
Enterasys B5 CLI Reference 17-25
Parameters
Defaults
IfaspecificACLisnotspecified,informationaboutallconfiguredARPACLsisdisplayed.
Mode
Switchcommand,read‐write.
Example
ThisexampledisplaysinformationabouttheARPACLnamedstaticARP.
B5(su)->show arpinspection access-list staticARP
ARP access list staticARP
permit ip host 192.168.1.10 mac host 00:01:22:33:44:55
permit ip host 192.168.1.20 mac host 00:0A:11:22:33:66
show arpinspection ports
UsethiscommandtodisplaytheARPconfigurationofoneormoreports.
Syntax
show arpinspection ports [port-string]
Parameters
Defaults
Ifaport‐stringisnotspecified,informationaboutallDAI‐enableduntrustedportsisdisplayed.
Mode
Switchcommand,read‐write.
Example
ThisexampledisplaystheARPconfigurationoflag.0.1.
B5(su)->show arpinspection ports lag.0.1
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
---------- ------------- ------------- ---------------
lag.0.1 No 15 1
acl‐name (Optional)SpecifiestheARPACLtodisplay.
port‐string (Optional)SpecifiestheportorportsforwhichtodisplayARP
configurationinformation.