Enterasys b5

show newaddrtrap
Enterasys B5 CLI Reference 7-33
show newaddrtrap
Usethiscommandtodisplaytheglobalandport‐specificstatusofthenewMACaddressestrap
function.
Syntax
show newaddrtrap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,thestatusofthenewMACaddressestrapfunctionwillbedisplayed
forallports.
Mode
Switchcommand,read‐only.
Usage
Bydefault,thisfunctionisdisabledgloballyandperport.
Example
ThisexampledisplaystheNewAddressTrapstateforports1through5inunit/slot1.
B5(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port Enable State
--------- ------------
ge.1.1 disabled
ge.1.2 disabled
ge.1.3 disabled
ge.1.4 disabled
ge.1.5 disabled
set newaddrtrap
Usethiscommandtoenableordisabletrapmessaging,globallyorononeormoreports,when
newsourceMACaddressesaredetected.
Syntax
set newaddrtrap [port-string] {enable | disable}
port‐string (Optional)DisplaysthestatusofthenewMACaddressestrapfunction
onspecificports.