Enterasys b5

Configuring RADIUS
22-6 Authentication and Authorization Configuration
Example
Thisexampleshowshowtoresettheauthenticationloginmethod.
B5(rw)->clear authentication login
Configuring RADIUS
Purpose
Toperformthefollowing:
•ReviewtheRADIUSclient/serverconfigurationontheswitch.
•EnableordisabletheRADIUSclient.
•Setlocalandremoteloginoptions.
•Setprimaryandsecondaryserverparameters,includingIPaddress,timeoutperiod,
authenticationrealm,andnumberofuserloginattemptsallowed.
•ResetRADIUSserversettingstodefaultvalues.
• ConfigureaRADIUS
accountingserver.
• ConfiguretheinterfaceusedforthesourceIPaddressoftheRADIUSapplicationwhen
generatingRADIUSpackets.
Commands
show radius
UsethiscommandtodisplaythecurrentRADIUSclient/serverconfiguration.
Syntax
show radius [status | retries | timeout | server [index | all]]
For information about... Refer to page...
show radius 22-6
set radius 22-8
clear radius 22-9
show radius accounting 22-10
set radius accounting 22-11
clear radius accounting 22-12
show radius interface 22-12
set radius interface 22-13
clear radius interface 22-14