Index -1
Index
Numerics
802.1D 9-1
802.1p 11-16, 12-1
802.1Q 10-1
802.1s 9-2
802.1w 9-1
802.1x 22-8, 22-23
A
Access Groups 22-86
Access Lists 22-83 to 22-84
Addresses
MAC, adding entries to routing
table 19-5
Advertised Ability 7-16
AES encryption protocol 8-10
Alias
node 14-39
ARP
dynamic inspection 17-16
entries, adding in routing mode 19-9
proxy, enabling 19-10
timeout 19-11
Authentication
EAPOL 22-23
MAC 22-25
Port web 22-68
RADIUS server 22-8, 22-11
SSH 22-81
Auto-negotiation 7-16
B
banner motd 3-25
Baud Rate 3-31
Broadcast
settings for IP routing 19-12
suppression, enabling on ports 7-35
C
CDP Discovery Protocol 6-1
CIDR 20-4
Cisco Discovery Protocol 6-7
Class of Service 11-7, 11-11,
11-16 to 11-22, 12-1
Class of Service (CoS) 11-16
Classification Policies 11-1
Clearing NVRAM 3-50
CLI
closing 3-48
scrolling screens 1-9
starting 1-6
Command History Buffer 14-14, 14-15
Command Line Interface. See also CLI
Configuration
clearing switch parameters 3-50
modes for router operation 18-2
Configuration Files
copying 3-44
deleting 3-45
displaying 3-43
executing 3-44
show running config 3-45
show running-config 19-7
Contexts (SNMP) 8-3
Copying Configuration or Image
Files 3-44
CoS
flood control 11-18
rate limiting 11-16
Cost
Spanning Tree port 9-40
D
Defaults
CLI behavior, described 1-8
factory installed 1-2
DES encryption protocol 8-10
DHCP server, configuring 16-1
DHCP snooping
basic configuration 17-3
database 17-2
overview 17-1
DHCP/BOOTP Relay 16-1
Dynamic ARP inspection
basic configuration 17-18
overview 17-16
Dynamic policy profile
assignment 22-3
E
EAP pass-through 22-2, 22-18
EAPOL 22-23
encryption protocol
SNMP 8-9
F
Flood control, via CoS 11-18
Flow Control 7-22
Forbidden VLAN port 10-14
G
Getting help xxxii
GVRP
enabling and disabling 10-23
purpose of 10-20
timer 10-25
H
Hardware
show system 3-15, 3-26
Help
keyword lookups 1-8
Host VLAN 10-18
hybrid authentication, about 22-52
I
ICMP 14-16
IGMP 13-1
enabling and disabling 13-2, 13-10
Image File
copying 3-44
downloading 3-31
Ingress Filtering 10-8, 10-11
Interface Configuration Mode 19-2
Interface(s)
configuring settings for IP 19-1
RIP passive 20-5
RIP receive 20-6
RIP send 20-8
IP
access lists 22-83 to 22-84
address, setting for a routing
interface 19-5
routes, adding in router mode 19-16
routes, managing in switch
mode 14-19
IPv6
addresses, setting 21-3
default router, setting 21-5
gateway, setting 21-5
management 21-1
Neighbor Discovery Protocol
displaying cache 21-7
IRDP 20-11
J
Jumbo Frame Support 7-14
K
Keyword Lookups 1-8
L
Line Editing Commands 1-10
Link Layer Discovery Protocol (LLDP)
configuring 6-13
LLDP
configuring 6-13
LLDP-MED
configuring 6-14
Lockout
set system 3-7
Logging 14-1
Login
administratively configured 1-7
default 1-7
setting accounts 3-2
via Telnet 1-6
M
MAC Addresses
displaying 14-22
MAC Authentication 22-25
To Next Page
Loading...
General