Enterasys b5

show lacp
Enterasys B5 CLI Reference 7-47
show lacp
Usethiscommandtodisplayinformationaboutoneormoreaggregatorports.
Syntax
show lacp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,linkaggregationinformationforallLAGswillbedisplayed.
Mode
Switchcommand,read‐only.
Usage
EachEnterasysB5moduleprovides6virtuallinkaggregatorports,whicharedesignatedinthe
CLIaslag.0.1throughlag.0.6.Onceunderlyingphysicalports(thatis,ge.x.x)areassociatedwith
anaggregatorport,theresultingaggregationwillberepresentedasoneLinkAggregationGroup
(LAG)withalag.x.xportdesignation.
Example
Thisexampleshowshowtodisplaylacpinformationforlag.0.1.Thefollowingtabledescribesthe
outputfields.
B5(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs: disabled
Aggregator: lag.0.1
Actor Partner
System Identifier: 00:01:F4:5F:1E:20 00:11:88:11:74:F9
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 0
Attached Ports: ge.1.1
ge.1.3
Table 7‐7providesanexplanationofthecommandoutput.
set lacp singleportlag 7-52
clear lacp singleportlag 7-51
show port lacp 7-53
set port lacp 7-54
clear port lacp 7-56
For information about... Refer to page...
port‐string (Optional)DisplaysLACPinformation forspecificLAGport(s).Valid
portdesignationsarelag.0.1‐6.