Enterasys b5 User Manual

show ip interface
19-4 IP Configuration
show ip interface
Usethiscommandtodisplayinformation,includingadministrativestatus,IPaddress,MTU
(MaximumTransmissionUnit)sizeandbandwidth,andACLconfigurations,forinterfaces
configuredforIP.
Syntax
show ip interface [vlan vlan-id] [loopback loop-id]
Parameters
Defaults
Ifinterfacetypeisnotspecified,statusinformationforallroutinginterfaceswillbedisplayed.
Mode
Anyroutermode.
Example
ThisexampleshowshowtodisplayconfigurationinformationforVLAN1:
B5(su)->router#show ip interface vlan 1
Vlan 1 is Admin DOWN
Vlan 1 is Oper DOWN
Primary IP Address is 192.168.10.1 Mask 255.255.255.0
Frame Type Ethernet
MAC-Address 0001.F45C.C993
Incoming Accesslist is not set
MTU is 6145 bytes
ARP Timeout is 1 seconds
Direct Broadcast Disabled
Proxy ARP is Disabled
Table 19‐1providesanexplanationofthecommandoutput.
vlanvlan‐id (Optional)DisplaysinformationforaspecificVLANinterface.This
interfacemustbeconfiguredforIProutingasdescribedin“Pre‐Routing
ConfigurationTasks”onpage 18‐1.
loopbackloop‐id (Optional)Displaysinterfaceinformationforaspecificloopbackinterface.
Table 19-1 show ip interface Output Details
Output Field What It Displays...
Vlan N Whether the interface is administratively and operationally up or down.
Primary IP Address Inteface’s primary IP address and mask. Set using the ip address command as
described in “ip address” on page 19-5.
Frame Type Encapsulation type used by this interface. Set using the arp command as described
in “arp” on page 19-9.
MAC-Address MAC address mapped to this interface.
Incoming Access
List
Whether or not an access control list (ACL) has been configured for ingress on this
interface using the commands described in “Configuring Access Lists” on
page 22-82.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English