Enterasys b5 User Manual

show pwa
Enterasys B5 CLI Reference 22-69
show pwa
Usethiscommandtodisplayportwebauthenticationinformationforoneormoreports.
Syntax
show pwa [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,PWAinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayPWAinformationforge.2.1:
B5(su)->show pwa ge.2.1
PWA Status - enabled
PWA IP Address - 192.168.62.99
PWA Protocol - PAP
PWA Enhanced Mode - N/A
PWA Logo - enabled
PWA Guest Networking Status - disabled
PWA Guest Name - guest
PWA Redirect Time - N/A
Port Mode AuthStatus QuietPeriod MaxReq
-------- ---------------- -------------- ----------- ---------
ge.2.1 disabled disconnected 60 16
Table 22‐8providesanexplanationofthecommandoutput.
port‐string (Optional)DisplaysPWAinformationforspecificport(s).
Table 22-8 show pwa Output Details
Output Field What It Displays...
PWA Status Whether or not port web authentication is enabled or disabled. Default state of
disabled can be changed using the set pwa command as described in “set pwa” on
page 22-70.
PWA IP Address IP address of the end station from which PWA will prevent network access until the
user is authenticated. Set using the set pwa ipaddress command as described in
“set pwa ipaddress” on page 22-73.
PWA Protocol Whether PWA protocol is CHAP or PAP. .
PWA Enhanced
Mode
Whether PWA enhanced mode is enabled or disabled. Default state of disabled can
be changed using the set pwa enhancedmode command as described in “set pwa
enhancedmode” on page 22-79.
PWA Logo Whether the Enterasys logo will be displayed or hidden at user login. Default state of
enabled (displayed) can be changed using the set pwa displaylogo command as
described in “set pwa displaylogo” on page 22-72.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English