Enterasys b5

set txqmonitor minrate Transmit Queue Monitoring Configuration
Enterasys B5 CLI Reference 5-3
Defaults
Thedefaultvalueis0,meaningthatdisabledportswillremaindisableduntilclearedmanuallyor
untiltheirnextlinkstatetransition.
Mode
Switchcommand,read‐write.
Usage
Whenthedowntimeisconfiguredas0,disabledportscanbemanuallyenabledusingtheclear
txqmonitordowncommand(page5‐4).
Example
Thisexamplesetsthedowntimeto3600seconds.
B5(su)-> set txqmonitor downtime 3600
set txqmonitor minrate
Usethiscommandtosettheminimumrate(inpacketspersecond)oftransmittedpacketsina
samplinginterval.
Syntax
set txqmonitor minrate rate
Parameters
Defaults
Onepacketpersecond.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetstheminimumrateofpacketspersecondpersamplingintervalto6.
B5(su)-> set txqmonitor minrate 6
set txqmonitor threshold
Usethiscommandtosetthetransmitqueuemonitoringthresholdlevelsfortriggeringactions
appliedtoastalledport.
Syntax
set txqmonitor threshold { [logging | ignorepause | disableinterface] value }
rate Thenumberofpacketspersecondthatmustbetransmittedper
samplinginterval,ifpacketsexistontheport’s transmitqueues.
Thedefaultvalueis1packetpersecond.