Enterasys b5

ip rip enable
Enterasys B5 CLI Reference 20-7
Mode
Routerconfiguration:B5(su)‐>router(Config‐router)#
Defaults
Ifmetricvalueisnotspecified,1willbeapplied.
Example
Thisexampleshows howtoredistributeroutinginformationdiscoveredthroughstaticrouteswill
beredistributedintoRIPupdatemessages:
B5(su)->router(Config)#router rip
B5(su)->router(Config-router)#redistribute static
Interface Configuration Commands
ThefollowingcommandsareusedtoconfigureRIPonspecificinterfaces.
ip rip enable
UsethiscommandtoenableRIPonaninterface.ThenoformofthiscommanddisablesRIPonan
interface:Bydefault,RIPisdisabledonallinterfaces.
Syntax
ip rip enable
no ip rip enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:B5(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableRIPontheVLAN1interface:
B5(su)->router(Config)#interface vlan 1
B5(su)->router(Config-if(Vlan 1))#ip rip enable
For information about... Refer to page...
ip rip enable 20-7
ip rip send version 20-8
ip rip receive version 20-8
ip rip authentication-key 20-9
ip rip message-digest-key 20-9