set snmp targetaddr
Enterasys B5 CLI Reference 8-27
Row status = active
Table 8‐9providesanexplanationofthecommandoutput.
set snmp targetaddr
UsethiscommandtoconfigureanSNMPtarget address.Thetargetaddressisauniqueidentifier
andaspecificIP addressthatwillreceiveSNMPnotificationmessagesanddetermi newhich
communitystringswillbeaccepted.ThisaddressconfigurationcanbelinkedtooptionalSNMP
transmitparameters(suchastimeout,retrycount,
andUDPport).
Syntax
set snmp targetaddr targetaddr ipaddr param param [udpport udpport] [mask mask]
[timeout timeout] [retries retries] [taglist taglist] [volatile | nonvolatile]
Parameters
Table 8-9 show snmp targetaddr Output Details
Output Field What It Displays...
Target Address Name Unique identifier in the snmpTargetAddressTable
.
Tag List Tags a location to the target address as a place to send notifications.
IP Address Target IP address.
UDP Port# Number of the UDP port of the target host to use.
Target Mask Target IP address mask.
Timeout Timeout setting for the target address.
Retry count Retry setting for the target address.
Parameters Entry in the snmpTargetParamsTable.
Storage type Whether entry is stored in volatile, nonvolatile or read-only memory.
Row status Status of this entry: active, notInService, or notReady.
targetaddr SpecifiesauniqueidentifiertoindexthesnmpTargetAddrTable.
Maximumlengthis32bytes.
ipaddr SpecifiestheIPaddressofthetarget.
paramparam SpecifiesanentryintheSNMPtargetparameterstable,whichisused
whengeneratingamessagetothetarget.Maximumlengthis32bytes.
udpportudpport (Optional)SpecifieswhichUDP
portofthetargethosttouse.
maskmask (Optional)SpecifiestheIPmaskofthetarget.
timeouttimeout (Optional)Specifiesthemaximumroundtriptimeallowedto
communicatetothistargetaddress.Thisvalueisin.01secondsandthe
defaultis1500(15seconds.)
retriesretries (Optional)Specifiesthenumberof
messageretriesallowedifaresponseis
notreceived.Defaultis3.
To Next Page
Loading...
General