Enterasys b5

show cos unit
Enterasys B5 CLI Reference 11-33
show cos unit
UsethiscommandtoshowpossibleCoSunitentries.
Syntax
show cos unit [irl [port-type index] [kbps]] [flood-ctrl [port-type index] [pps]]
Parameters
Defaults
Ifnoparametersareentered,allCosunitinformationisdisplayed.
Mode
Switchcommand,read‐only.
Examples
Thisexampleshowspossibleunitentriesforinboundratelimiting:
B5(su)->show cos unit irl
Type: Unit:
irl = inbound rate limiting Kbps = Kilobits per second
Port Type Type Unit Maximum Rate Minimum Rate Granularity
--------- ---- ---- ------------ ------------ -----------
0 irl Kbps 1000000 64 1
Thisexamplesshowsfloodcontrolunitinformation.
B5(su)->show cos unit flood-ctrl
Type: Unit:
flood-ctrl = flood control type pps = packets per second
Port Type Type Unit Maximum Rate Minimum Rate Granularity
----------- ----------- ---- ------------ ------------ -----------
0 flood-ctrl pps 148810 0 1
clear cos all-entries
UsethiscommandtoclearallClassofServiceentriesexceptentries0‐7.
Syntax
clear cos all-entries
irl (Optional)DisplayonlyIRLunitinformation.
port‐typeindex (Optional)Displayinformationaboutthespecifiedporttype.(Only
port‐typeindex0issupported.)
kbps (Optional)Displaykbpsinformation.
flood‐ctrl (Optional)Displayonlyfloodcontrolunitinformation.
pps (Optional)Displayppsinformation.