Enterasys b5

show spantree spanguardtimeout
Enterasys B5 CLI Reference 9-27
show spantree spanguardtimeout
UsethiscommandtodisplaytheSpanningTreeSpanGuardtimeoutsetting.
Syntax
show spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSpanGuardtimeou tsetting:
B5(su)->show spantree spanguardtimeout
Spanguard timeout: 300
set spantree spanguardtimeout
Usethiscommandtosettheamountoftime(inseconds)anedgeportwillremainlockedbythe
SpanGuardfunction.
Syntax
set spantree spanguardtimeout timeout
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosettheSpanGuardtimeoutto600seconds:
B5(su)->set spantree spanguardtimeout 600
timeout Specifiesatimeoutvalueinseconds.Validvaluesare0to65535.
Avalueof0willkeeptheportlockeduntilmanuallyunlocked.Thedefault
valueis300seconds.