Enterasys b5

clear snmp targetaddr
8-28 SNMP Configuration
Defaults
Ifnotspecified,udpportwillbesetto162.
Ifnotspecified,maskwillbesetto255.255.255.255
Ifnotspecified,timeoutwillbesetto1500.
Ifnotspecified,numberofretrieswillbesetto3.
Iftaglistisnotspecified,nonewillbeset.
Ifnotspecified,storagetype
willbenonvolatile.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoconfigureatrapnotificationcalled“TrapSink.”Thistrapnotification
willbesenttotheworkstation192.168.190.80(whichistargetaddress“tr”).Itwillusesecurity
andauthorizationcriteriacontainedinatargetparametersentrycalled“v2cExampleParams”.For
moreinformationonconfiguringabasicSNMPtrap,
referto“CreatingaBasicSNMPTrap
Configuration”onpage 8‐36:
B5(su)->set snmp targetaddr tr 192.168.190.80 param v2cExampleParams taglist
TrapSink
clear snmp targetaddr
UsethiscommandtodeleteanSNMPtargetaddressentry.
Syntax
clear snmp targetaddr targetAddr
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
taglisttaglist (Optional)SpecifiesalistofSNMPnotifytagvalues.Thistagsalocation
tothetargetaddressasaplacetosendnotifications.Listmustbe enclosed
inquotesandtagvaluesmustbeseparatedbyaspace(forexample,
“tag1tag2”).
volatile|

nonvolatile
(Optional)Specifiestemporary(default),orpermanentstorageforSNMP
entries.
targetAddr Specifiesthetargetaddressentrytodelete.