Enterasys b5

Starting and Configuring Telnet
3-36 Basic Configuration
Do you want to reset now (y/n) [n]?n
B5(su)->dir
Images:
==================================================================
Filename: b5-series_06.42.00.0026 (Active)
Version: 06.42.00.0026
Size: 9405440 (bytes)
Date: Fri Jul 18 12:48:35 2008
CheckSum: f1626ccf10d8f48cd6c3e79ab602342a
Compatibility: <platform specific>
Filename: b5-series_06.42.03.0007 (Boot)
Version: 06.42.03.0007
Size: 8290304 (bytes)
Date: Fri May 9 11:35:27 2008
CheckSum: 9f820d79239f10890442f8ff1f2bc914
Compatibility: <platform specific>
Starting and Configuring Telnet
Purpose
ToenableordisableTelnet,andtostartaTelnetsessiontoaremotehost.TheEnterasysB5switch
allowsatotaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Commands
show telnet
UsethiscommandtodisplaythestatusofTelnetontheswitch.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show telnet 3-36
set telnet 3-37
telnet 3-37