Enterasys b5

show sflow interface
Enterasys B5 CLI Reference 24-15
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ThiscommandallowsyoutoconfigurethemanagementinterfaceusedbythesFlowAgentwhen
sendingsamplingdata gramstothesFlowCollector.Anyoftheinterfaces,includingVLAN
routinginterfaces,canbeconfiguredasthemanagementinterface.
AninterfacemusthaveanIPaddressassignedtoitbeforeitcanbe
setbythiscommand.
Ifnointerfaceisspecified,thentheHostVLANwillbeusedasthemanagementinterface.
Ifanon‐loopbackinterfaceisconfiguredwiththiscommand,applicationpacketegressis
restrictedtothatinterfaceiftheservercanbereachedfromthatinterface.Otherwise,thepackets
are
transmittedoverthefirstavailableroute.Packetsfromtheapplicat ion serverarereceivedon
theconfiguredinterface.
Ifaloopbackinterfaceisconfigured,andtherearemultiplepathstotheapplicationserver,the
outgoinginterface(gateway)isdeterminedbasedonthebestroutelookup.Packetsfromthe
applicationserverarethen
receivedonthesendinginterface.Ifrouteredundancyisrequired,
therefore,aloopbackinterfaceshouldbeconfigured.
Example
ThisexampleconfiguresanIPaddressonVLANinterface100andthensetsthatinterfaceasthe
managementinterfaceforthesFlowAgent.
B5(rw)->router(Config-if(Vlan 100))#ip address 192.168.10.1 255.255.255.0
B5(rw)->router(Config-if(Vlan 100))#exit
B5(rw)->router(Config)#exit
B5(rw)->router#exit
B5(rw)->router>exit
B5(rw)->set sflow interface vlan 100
B5(rw)->show sflow interface
vlan 100 192.168.10.1
show sflow interface
UsethiscommandtodisplaytheinterfaceusedbythesFlowAgentwhensendingsampling
datagramstothesFlowCollector.
Syntax
show sflow interface
Parameters
vlanvlan‐ID SpecifiestheVLANinterfacetobeused.Thevalueofvlan‐IDcanrange
from1to4093.