To Next Page

To Previous Page

Packet Capture Commands

15-22 RMON Configuration

Packet Capture Commands

Notethatpacketcapturefilterissamplingonlyanddoesnotguaranteereceiptofback‐to‐back

packets.

Purpose

TodisplayRMONcaptureentries,configure,enable,ordisablecaptureentries,andclearcapture

entries.

Commands

show rmon capture

UsethiscommandtodisplayRMONcaptureentriesandassociatedbuffercontrolentries.

Syntax

show rmon capture [index [nodata]]

Parameters

Defaults

Ifnooptionsarespecified,allbuffercontrolentriesandassociatedcapturedpacketswillbe

displayed.

Mode

Switchcommand,read‐only.

Example

ThisexampleshowshowtodisplayRMONcaptureentriesandassociatedbufferentries:

B5(rw)->show rmon capture

Buf.control= 28062 Channel= 38283 EntryStatus= valid

----------------------------------------------------------

FullStatus avail FullAction lock

Captured packets 251 Capture slice 1518

Download size 100 Download offset 0

Max Octet Requested 50000 Max Octet Granted 50000

Start time 1 days 0 hours 51 minutes 15 seconds

For information about... Refer to page...

show rmon capture 15-22

set rmon capture 15-23

clear rmon capture 15-24

index (Optional)Displaysthespecifiedbuffercontrolentryandallcaptured

packetsassociatedwiththatentry.

nodata (Optional)Displaysonlythebuffercontrolentryspecifiedbyindex.

Enterasys b5 User Manual

Questions and Answers: