Enterasys b5 User Manual

show cdp
6-2 Discovery Protocol Configuration
show cdp
UsethiscommandtodisplaythestatusoftheCDPdiscoveryprotocolandmessageintervalon
oneormoreports.
Syntax
show cdp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,allCDPinformationwillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayCDPinformationforportsge.1.1throughge.1.9:
B5(su)->show cdp ge.1.1-9
CDP Global Status :auto-enable
CDP Version Supported :30 hex
CDP Hold Time :180
CDP Authentication Code :00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 hex
CDP Transmit Frequency :60
Port Status
-----------------
ge.1.1 auto-enable
ge.1.2 auto-enable
ge.1.3 auto-enable
ge.1.4 auto-enable
ge.1.5 auto-enable
ge.1.6 auto-enable
ge.1.7 auto-enable
ge.1.8 auto-enable
ge.1.9 auto-enable
Table 6‐1providesanexplanationofthecommandoutput.
port‐string (Optional)DisplaysCDPstatusforaspecificport.Foradetaileddescription
ofpossibleport‐stringvalues,referto
“Port String Syntax Used in the CLI”on
page7‐1.
Table 6-1 show cdp Output Details
Output Field What It Displays...
CDP Global Status Whether CDP is globally auto-enabled, enabled or disabled. The default state of
auto-enabled can be reset with the set cdp state command. For details, refer to “set
cdp state” on page 6-3.
CDP Versions
Supported
CDP version number(s) supported by the switch.
CDP Hold Time Minimum time interval (in seconds) at which CDP configuration messages can be
set. The default of 180 seconds can be reset with the set cdp hold-time command.
For details, refer to “set cdp hold-time” on page 6-5.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English