Enterasys b5

set logging default
Enterasys B5 CLI Reference 14-5
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThiscommandshowshowtodisplaytheSyslogserverdefaultvalues.Foranexpla n ationofthe
commandoutput,referbacktoTable 14‐1onpage 14‐3.
B5(su)->show logging default
Facility Severity Port
-----------------------------------------
Defaults: local4 warning(5) 514
set logging default
Usethiscommandtosetloggingdefaultvalues.
Syntax
set logging default {[facility facility] [severity severity] port port]}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
facilityfacility Specifiesthedefaultfacilityname.Validvaluesare:local0tolocal7.
severityseverity Specifiesthedefaultloggingseveritylevel.Validvaluesand
correspondinglevelsare:
1—emergencies(systemisunusable)
2—alerts(immediateactionrequired)
3—criticalconditions
4—errorconditions
5—warningconditions
6
—notifications(significantconditions)
7—informationalmessages
8—debuggingmessages
portport Specifies thedefaultUDPporttheclientusestosendtotheserver.