set pwa
22-70 Authentication and Authorization Configuration
set pwa
Usethiscommandtoenableordisableportwebauthentication.
Syntax
set pwa {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoenableportwebauthentication:
B5(su)->set pwa enable
PWA Guest
Networking Status
Whether PWA guest user status is disabled or enabled with RADIUS or no
authentication. Default state of disabled can be changed using the set pwa
gueststatus command as described in “set pwa gueststatus” on page 22-75.
PWA Guest Name Guest user name for PWA enhanced mode networking. Default value of “guest” can
be changed using the set pwa guestname command as described in “set pwa
guestname” on page 22-74.
PWA Guest
Password
Guest user’s password. Default value of an empty string can be changed using the
set pwa guestpassword command as described in “set pwa guestpassword” on
page 22-75.
PWA Redirect Time Time in seconds after login success before the user is redirected to the PWA home
page.
Port PWA port designation.
Mode Whether PWA is enabled or disabled on his port.
Auth Status Whether or not the port state is disconnected, authenticating, authenticated, or held
(authentication has failed).
Quiet Period Amount of time a port will be in the held state after a user unsuccessfully attempts to
log on to the network. Default value of 60 can be changed using the set pwa
quietperiod command as described in “set pwa quietperiod” on page 22-76.
MaxReq Maximum number of log on attempts allowed before transitioning the port to a held
state. Default value of 2 can be changed using the set pwa maxrequests command
as described in “set pwa maxrequest” on page 22-77.
Table 22-8 show pwa Output Details (Continued)
Output Field What It Displays...
enable|disable Enablesordisablesportwebauthentication.
To Next Page
Loading...
General