Enterasys b5

Enterasys B5 CLI Reference 7-1
7
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Port String Syntax Used in the CLI
Commandsrequiringaport‐stringparameterusethefollowingsyntaxtodesignateporttype,slot
location,andportnumber:
porttype.unit_or_slotnumber.portnumber
Whereporttypecanbe:
fefor100‐MbpsEthernet
gefor1‐GbpsEthernet
tgfor10‐GbpsEthernet
hostforthehostport
vlanforvlaninterfaces
lagfor
IEEE802.3linkaggregationports
Whereunit_or_slotnumbercanbe:
1‐8forswitchunitsinastack
For information about... Refer to page...
Port Configuration Summary 7-1
Reviewing Port Status 7-2
Disabling / Enabling and Naming Ports 7-7
Setting Speed and Duplex Mode 7-11
Enabling / Disabling Jumbo Frame Support 7-14
Setting Auto-Negotiation and Advertised Ability 7-16
Setting Flow Control 7-22
Setting Port Link Traps and Link Flap Detection 7-24
Configuring Broadcast Suppression 7-35
Port Mirroring 7-38
Link Aggregation Control Protocol (LACP) 7-44
Configuring Protected Ports 7-58