Enterasys b5

clear spantree adminpathcost
Enterasys B5 CLI Reference 9-39
Example
Thisexampleshowshowtosettheadminpathcostto200forge.3.2onSID1:
B5(su)->set spantree adminpathcost ge.3.2 200 sid 1
clear spantree adminpathcost
UsethiscommandtoresettheSpanningTreedefaultvalueforportadminpathcostto0.
Syntax
clear spantree adminpathcost port-string [sid sid]
Parameters
Defaults
Ifsidisnotspecified,adminpathcostwillberesetforSpanningTree0.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresettheadminpathcostto0forge.3.2onSID1:
B5(su)->clear spantree adminpathcost ge.3.2 sid 1
show spantree adminedge
Usethiscommandtodisplaytheedgeportadministrativestatusforaport.
Syntax
show spantree adminedge [port port-string]
Parameters
Defaults
Ifport‐stringisnots pecifiededgeportadministrativestatuswillbedisplayedforallSpanningTree
ports.
port‐string Specifiestheport(s)forwhichtoresetadminpathcost.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 7‐1.
sidsid (Optional)ResetstheadminpathcostforspecificSpanningTree(s).
Validvaluesare0‐4094.Ifnotspecified,SID0isassumed.
port‐string (Optional)Displaysedgeportadministrativestatusforspecific
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage 7‐1.