Enterasys b5

show sflow receivers
Enterasys B5 CLI Reference 24-5
show sflow receivers
UsethiscommandtodisplaythecontentsofthesFlowReceiversTable,ortodisplayinformation
aboutaspecificsFlowCollectorlistedinthetable.
Syntax
show sflow receivers [index]
Parameters
Defaults
ThecontentsofthesFlowReceiversTableisdisplayed.
Mode
Switchcommand,read‐only.
Usage
ExecutingthiscommandwithoutspecifyinganindexintothesFlowReceiversTabledisplays
informationaboutalltheCollectorsconfiguredontheswitch.
IfyouspecifyanindividualCollectorbyitsindexnumber,additionalinformationisdisplayedfor
thatCollector.
Examples
ThisexampledisplaysthesFlowReceiversTable.
B5(su)->show sflow receivers
Receiver Owner Time out Max Datagram Port IP Address
Index String Size
-------- -------- ---------- ------------ ----- -------------------
1 ets1 17766 1400 6343 10.1.2.117
ThisexampledisplaysinformationabouttheCollectorwithindex1.
B5(su)->show sflow receivers 1
Receiver Index 1
Owner String ets1
Time out 17758
clear sflow port sampler 24-14
set sflow interface 24-14
show sflow interface 24-15
clear sflow interface 24-16
show sflow agent 24-17
For information about... Refer to page...
index (Optional)SpecifiesaspecificCollectortodisplayinformationabout.